Reinforcing grid protection, control, and automation

Real-time monitoring and control of the MV network, including switchgear and breaker status, alarms, and battery conditions. Execution of remote operations like opening, closing, isolating faults, and restoring service directly from the control center — improving reliability, safety, and efficiency.

Monitoring key electrical parameters such as voltages, currents, power, power factor, and frequency through sensors installed on MV breakers. In case of anomalies like short circuits, overloads, or earth faults, it automatically triggers breaker trips to protect assets and ensure operator safety.

Interrupting power in case of faults such as short circuits or earth faults, and automatically reclosing the circuit after a brief delay to restore service when the fault is cleared, improving reliability and reducing outage duration.

Performing predefined switching operations in MV substations based on fixed time delays when a fault occurs, without requiring input from the control center. It opens the breaker or switch after a preset delay to isolate the faulty section, then recloses it after another configurable interval. If the fault was temporary, power is restored automatically; if it persists, the breaker trips again to protect the network.

Detecting the fault instantly using sensors, isolating the faulted section by opening switches, and reconfiguring the grid to restore power to unaffected areas in under one second.